Categories
Statistics
Flag Counter
Since 08.08.2014
Counts only, if "DNT = disabled".

Your IP is 54.157.61.194
ec2-54-157-61-194.compute-1.
Info
Valid HTML 4.01 Transitional Creative Commons Lizenzvertrag
rss
เราจะทำแบบวิศวกรผู้ยิ่งใหญ่
We love the King
19. March 2024
further reading
Your valuable opinion :
5 stars

Avg. 5.00 from 4 votes.



calc_16.php    6016 Bytes    12-02-2018 11:22:33


Diplexer Calculator (Lowpass)




A diplexer presents a broadband termination to e.g. a mixer, which is connected on the left side. Due to the inductor, the input resistance of the next stage e.g. the if - amplifier needs only to present a good match for some low frequencies, which can pass the inductor. Higher frequencies are shorted via the capacitor to the correct load of 50 Ω. The drawbacks are noted below the calculator.



Schema Diplexer


Frequency

 [MHz]

Impedance

 [Ω]

Capacitor

 [pF]

Inductor

 [nH]

Resistor

 [Ω]

   

 


Schema Diplexer



It can be seen clearly that 50% of the power is dissipated in each of the resistors. ( at the frequency where the diplexer is designed for ). The IF-Amplifier will see only half of the available power. If you want to avoid this use the Bridged Tee Configuration (Bandpass).





✈ Share your thoughts



The webmaster does not read these comments regularely. Urgent questions should be send via email. Ads or links to completely uncorrelated things will be removed.


Your Browser says that you allow tracking. Mayst we suggest that you check that DNT thing ?

 
t1 = 6459 d

t2 = 260 ms

★ ★ ★  Copyright © 2006 - 2024 by changpuak.ch  ★ ★ ★

PRchecker.info Impressum